MC Rubble Brush Loads

Forums SparkQuest Spark Crafters MC Rubble Brush Loads

  • MC Rubble Brush Loads

    Posted by profmag on December 15, 2020 at 8:25 pm

    We’ve been making a destroyed version of E-Land New City for a SQ set. After destroying a lot of buildings, we decided to add rubble to the ground. One of the easiest ways to do this is to use the cyl brush loaded with a materials with lots of air. Here are some of the brush loads:

    //br cyl 80%air,15%stone;15%glass,15%oak_plank 6 2
    //br cyl 80%air,15%stone 6 2
    //br cyl 80%air,15%stone,15%ice 6 2
    //br cyl 80%air,15%stone,15%iron_block 6 3
    //br cyl 80%air,15%stone,15%diamond_block 6 2
    //br cyl 80%air,15%iron_block 6 1

    The two numbers at the end determine the radius and the height of the cylinder.

    To set the blocks above the ground (rather than in the ground), place a block on top of the ground and target it before making a brush stroke.

    If blocks are left hanging in the air, use the gravity brush to put them down:

    //brush gravity 6

    By loading your inventory bar with different axes (or any other tool), you can pin the different brush commands to different tools saving having to type in the commands over and over.

    profmag replied 3 years, 11 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.